Start with what the project requires.
Upload the pre-construction information, the drawings and the specification. Ramsgen reads them and lists what the project requires of you: the permits, the site rules, the services and the restrictions. Each requirement is cited to the page it came from.
What to upload
The pre-construction information, the client's construction phase plan, the drawings, the specification and the site investigation. Upload whatever you were given, in the form you were given it.
Ramsgen reads every document and lists what the project requires of you. Each requirement keeps the page it came from, so you can open the source and check it.
- Asset protection permit required before any excavation within 3 m of the gas main.Page 14
- 11 kV overhead line crosses plots 18 to 22.Page 9
- The footway stays open to the public for the duration of the works.Page 22
- Site induction must cover the client's traffic management plan.Page 31
Requirements read off a pre-construction information pack, each carrying its page.
One set of requirements for every document
Everything you create or review in the project works from the same requirements. A new RAMS or construction phase plan is written with them applied clause by clause. A RAMS from your supply chain is checked against them.
When the client asks where a control came from, you can show them the page in their own pack.
One project, one record
Each project keeps its own documents and its own history, separate from every other job. Every document and every review is saved against the project with the date it was done, so you can show what was checked and when.